![]() ![]() The Alphabetic Index does not always provide the full code. Tabular List: A chronological list of ICD-10-CM codes divided into chapters based on body system or condition. What is the difference between alphabetic index and tabular list? Modifying terms that more specifically identify a main term also may be listed. The Index is an alphabetical listing of the main terms, synonyms, and abbreviations in the CPT book. These codes are identified with a symbol to the left of the CPT code. Where is the alphabetic index located in the CPT book? Code the surgical diagnosis – The reason the patient is having surgery. 81 – Encounter for pre-procedural examinations. When a patient presents for outpatient surgery the reason for the surgery is coded as? What is the main term in the alphabetic index for Kaposi sarcoma?Ģ022 ICD-10-CM Diagnosis Code C46. Even if a dash is not included at the Alphabetic Index entry, it is necessary to refer to the Tabular List to verify that no 7th character is required. When two codes are separated by a hyphen in the alphabetic index What does this indicate?Ī dash (-) at the end of an Alphabetic Index entry indicates that additional characters are required. It is essential to use both the Alphabetic Index and the Tabular List to locate and assign a code that corresponds to a diagnosis or reason for visit. What is the appropriate use of the alphabetic index and tabular list? It describes an “unlisted procedure, arthroscopy.” Unlisted codes can be used only when no Category I or Category III code provides an exact match to the medical documentation. Unlisted Procedure or Service Code For example, code 29999 is found in the Surgery section, Musculoskeletal subsection. What does the CPT Alphabetic Index relies on? The default code represents that condition that is most commonly associated with the main term, or is the unspecified code for the condition. When a code is listed next to a main term in the alphabetic index it is known as a main code?ĭefault codes A code listed next to a main term in the ICD-10-CM Alphabetic Index is referred to as a default code. Topography codes are identified by the letter C, the first character of codes in Chapter II ICD-10. The index also includes selected tumor-like lesions and conditions. ![]() The alphabetical index is used to code topography (anatomical sites) and morphology (histological terms). What is the purpose of the alphabetical index? Referring to the Tabular List to verify that no other character is required. It is important to use both the Alphabetic Index and Tabular List to code because the Alphabetic Index does not always give the full code. Should you code from the alphabetic index if not what should you reference? It does not always provide the full code. The Alphabetic Index helps you determine which section to refer to in the Tabular List.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |